Payment & Shipping Terms:
|Type:||Drill Bit||Machine Type:||Drilling Tool|
|Use:||Coal Mining||Sharpening Angle:||110°|
Pd125 Pneumatic Chisel Bit and Integral Drill Rod Grinder;grinding wheel for carbide
In order to extend Drill Bits 's life,sharpening and grinding tungsten carbide button is very necessary, due to cemented carbide tip cost is very costly. Prodrill provides an extensive range of Top hammer percussive and DTH rock tool drilling accessories etc, and also supply the full package of Top hammer & DTH drilling support and consumble products such as diamond grinding cup or pin and button bit grinding equipemnt which is needed to get the job done and done right.
In abrasive conditions, wear to the tungsten carbide buttons can destroy a drill bit after only a very short life. It is adviseable therefore, when drilling in abrasive conditions that suitable grinding equipment is available.
PD125 pneumatic grinding machine is designed for grinding the chisel bits and integral drill rods, Your worn bit or rod can be reused after being grinded by our grinding machine to prolong their service life and save your money.It is hand-held using ,very convenient.And we have CE certificate for this machine. Its capable for re-grinding of Blunted Drill Steel Rods at an angle of 110.Since the Grinder machine is subjected for arduous working conditions in the mines, quarried.The Grinder is now developed with specialized design and mounted on Drill Steel Rods,possessing high design and mounted on Drill Steel Rods,possessing high strength balance and easy to transport and simple to setup,and extend drill life more 30% after corect use.And Grinding Wheels size 125mm*63mm*31.75mm.
1. During operation, if the sound is abnormal, it should be shut down immediately for maintenance. The temperature rise of the motor should be within the specified range.
2. The motor of the grinding machine must not be equipped with a reverse switch. When the power is off, the power should be turned off.
3. When grinding, wear protective glasses and gloves. The operator should stand on the side of the grinding wheel and strictly not stand on the front of the rotating grinding wheel.
4. When grinding, use the coolant to cool, do not install the bit on the drill rod for grinding.
|PD125 pneumatic chisel bit/integral drill rod grinder|
|Rotation speed||3500 RPM max|
|Operating pressure insufficient||6.0bar|
|Air consumption at 6 bar||1.5mc/min|
|Abrasive grinder diameter||152mm|
|Bench version weight||36kg|
|Portable version weight||37kg|